When you have finished all the preparation and priming, it's time to apply the finishing paint to the coating and the edge. In most cases, you'll want to paint your house's siding first and then paint the border. After the coating is dry, you can go back and paint windows, shutters and any corner moldings. If you have a firm hand and time to spend slowly painting edges and corners, this could be your method.
However, the painting tips from Nicole Gibbons, founder of Clare's, simplify the entire process and make it easier to choose paint. Since this coat is usually done with high-gloss (and occasionally oil-based) paint, you don't want droplets of this paint to reach the wall, where the gloss could show through the matte paint that will be applied next. A suitable paint also protects the house by placing a preventive barrier against wind, water and other weather threats. If you paint the molding first, you run the risk of the wall's color splashing and you'll have to retouch it.
This particular order allows DIYers to be a little more careless when painting walls without making the work itself look sloppy. There are advantages and disadvantages to any way you decide to approach it, explains Chip Gaines, former co-anchor of Fixer Upper and visionary of the KILZ brand of primers and paints. However, if you're seeing a cramped or small room, you might want to paint the ceiling, wall, and molding the same color. See these instructions for painting doors with raised panels and see below for the steps for painting windows and shutters.
A bedroom (15 × 1) with the front door molding, closet door molding, baseboards, and two window frames should take about 2 hours to prepare and prime, and then 2 to 4 hours to paint. Use an extension ladder and be sure to cover the ends where it comes in contact to avoid damaging the new paint. To paint or stain plywood siding, work on a manageable strip of 3 or 4 feet at a time and work from top to bottom of the house before moving on to the next strip. It is best to paint these surfaces with a brush about 2 ½ inches wide or more to cover the horizontal stretches.
If you're painting walls after moldings, the latter can catch droplets on the walls and need retouching. If you're painting shutters, try removing them to make them work and then rehang them when you're done.
Leave Reply